久热这里只有精品12,国产极品美女高潮无套在线观看,国产成人综合色就色综合,国内精品久久久久久不卡影院

Language : 簡體中文 | English

Part#/KeywordCode
Products News
Location Products News How to Make TVS Effective in Circuit Application

How to Make TVS Effective in Circuit Application


How to Make TVS Effective in Circuit Application




TVS devices shall be used on all data and power lines located on I/O connectors in and out of PCB. Make the TVS device as close to the noise source as possible to ensure that the surge voltage can be clamped before the pulse is coupled to the adjacent PCB wire.



How to make TVS effective in circuit application? The wiring of printed circuit board and the selection of circuit components are very important. Through the reasonable placement of TVS position, grounding selection, parasitic inductance and loop area processing, the scientific and reasonable PCB wiring and TVS tube selection can make TVS more efficient.




PCB Layout Guide



position




TVS devices shall be used on all data and power lines located on I/O connectors in and out of PCB. Make the TVS device as close to the noise source as possible to ensure that the surge voltage can be clamped before the pulse is coupled to the adjacent PCB wire. In addition, shorter TVS conductor shall be used for PCB to reduce surge energy consumption. Put sensitive wires in the center to avoid ESD during processing.



Grounding selection




If possible, the protection circuit shall shunt the surge voltage to the reference or case grounding. Shunting the surge voltage directly to the signal grounding of the integrated circuit will cause grounding rebound. The clamping performance of TVS diodes on a single grounded PCB can be improved by reducing the impedance with relatively short and wide grounding wires.



Parasitic inductance




The parasitic inductance of PCB layout and integrated circuit package will cause obvious overshoot of TVS clamping voltage. The inductance of PCB can be reduced by using short wires and multi-layer discrete grounding and power boards. Small SMT can reduce the inductance of the package.



Loop area




Reducing the loop area formed by high-speed data and grounding wires can reduce the impact of radiation and RF. Especially when the conductor is long, an effective way to alleviate the loop problem is to include a ground plate in the PCB design, increase the TVS tube, and provide isolation for separation intervals between integrated circuits. But it will increase the loop area.


Cooperation Brand

国产精品爽爽VA在线观看网站| 最刺激的仑乱在线观看| 欧美阿v高清资源不卡在线播放| 人成乱码一卡二卡三四卡无卡六卡| 亚洲国产精品久久青草无码| 最新国产毛2卡3卡4卡|